Frequent question: How do I pair my Oricom baby monitor?

(1) Switch on the parent unit. (2) On monitor mode, press and hold key for 5 seconds, it will go to registration mode. (3) After registration icon [ ] comes up on screen, press or to select the camera channel [C1] or [C2] or [C3] or [C4] that you want the baby unit to pair with.

How do I connect my baby monitor?

Press and hold the Pair button on the Baby unit till you hear the beep sound. The monitor will then find, pair, and get video from the camera.

Why does my Oricom monitor vibrate?

(3) The vibration will activate when there is a temp alert or a loud noise from the baby unit. When the vibration alarm is activated, the parent unit vibrates when the sound in the room being monitored is so loud that the red sound level LED’s are activated.

How do I turn up the volume on my Orricom baby monitor?

Once the baby and parent units are switched on the parent unit will show the video captured by the baby unit. During video mode, you can press the key to enable sound level adjustment, you can now adjust the volume by pressing the / keys.

IT IS INTERESTING:  Your question: Should a 3 year old sleep in a crib?

How do I reset my baby monitor?

Press and hold the reset button on the bottom of the Smart Baby Monitor while the power cord is connected. Hold until the green LED on the front of long flashes and turns off.

How do I reset my Oricom 850 monitor?

Press and hold the power button until the Oricom logo appears on the parent unit. The camera image will then appear. Press and hold the power button for approx. 1 second to switch the unit off.

Why is my Motorola baby monitor not connecting?

Reset the units by disconnecting them from the electrical power and use a pin to press the reset key until you either hear a beep, or the monitor turns off. Wait about 15 minutes before plugging the units back in. Allow up to one minute for the camera and the parent unit to synchronize.

How do you zoom in with an Oricom monitor?

4.11 Zoom Mode

(1) When the parent unit is in x1 viewing mode, press and hold key for 2 seconds. (2) The live viewing area will change to x2 zoom mode immediately. At the same time four direction arrows will appear in the middle of the display. (3) Press and to move the display up and down.

How do I change the channel on my Oricom UHF?

UP/DOWN Buttons – Press to change channels, volume, and to select settings during programming. MENU Button – Press to change To switch between Modes CALL button – Press to send Ringing tone to other radios. PWR/VOL Switch – Rotate clockwise/counter clockwise to turn the unit ON or OFF. Channel number.

IT IS INTERESTING:  Frequent question: Is it bad to carry a dog like baby?